|
Wire EDM DESIGN--Index WIRE EDM ((EDMOND=>>EDM(Electric Discharge Machining)+ OND(Onderzoek)) ABSTRACT We are astonished about a few facts: -to scharpen the wire to get it through the WEDM nozlles, we use a lighter to melt the 0.25mm brass wire. -using the secunday of a 25VA 24V 50c/s transformer, the wire of 0.25mm melts. -watching the youtube video's, which show the VA-meters, these machines run at DC 70V and 1.3A; a whisper of power. -a machine to replace our AGIE costs at Sodick 320.000 Euro for a huge aquarium. -molybdenum promises speeds x5 x10. -in this video this polish guy runs LinuxCNC at 20mm/min, pulling on the wire and no shorts; only using motion.enable. CONCLUSION=IT IS LINUXCNC TIME; in this little research, we want to find out the proper process parameters for the generator, the gap detector and the drives.(15/09/2017) |